FPGA/Artix-7-35T
< FPGA
Version vom 23. September 2019, 16:23 Uhr von Tw (Diskussion | Beiträge)
Datei:Artix 7 Back 1.jpg
Artix-7 FPGA Board
Digilent Arty Artix-7
The Digilent Artix-7 is a small, 48-pin DIP form factor board built around a Xilinx Artix 7 FPGA. The board also includes a USB-JTAG programming circuit, USB-UART bridge, clock source, Pmod host connector, SRAM, Quad SPI Flash, and basic I/O devices. These components make it a formidable, albeit compact, platform for digital logic circuits and Microblaze embedded softcore processor designs alike. There are 44 Digital FPGA I/O signals and 2 FPGA Analog inputs that are routed to 100-mil-spaced through-hole pins so that you can integrate your programmable logic design directly into a solderless breadboard circuit. At just .7” by 2.75” inches, it can also be loaded in a standard socket and used in embedded systems.
Spezifikation
- Artix-7 35T (LUTs 20.800 / Flip-flops 20.800)
- Block RAM 225KB
- SRAM 512KB (8-bit Bus, 8ns)
- Quad-SPI Flash 4MB
- Pmod Connector
- Connector 48-pin DIP (44 Digital I/O, 2 Analog inputs 0-3.3V)
- 2 Taster
- 2 LEDs
- 1 RGB LED
Dokumentation
- Arty Artix-7 Reference Manual
- Arty Artix-7 Schematic
- Artix 7 Datasheet
- Xilinx 7 Series FPGAs Overview
